Installing the Zebra ZD621 to your Computer
Step 1: Run through the Connection Wizard on your Zebra printer. The Wizard library is located on the Home screen of your printer below Menu. See Connection Wizard Guide below:
CONNECTION WIZARD GUIDE:
- Wired IP Protocol - Select 'All'
- Wi-Fi Country Code - Select 'USA/Canada'
- Wi-Fi Security - Select 'WPA-PSK' (Pre-Shared Key)
- WPA-PSK - Enter your Wi-Fi's password (case sensitive)
- Wi-Fi Band - Select 'All'
- ESSID - Enter the name of your Wi-Fi network (case sensitive)
- Wired IP Protocol - Select 'All'
- Bluetooth - Select 'On'
- Bluetooth Discovery - Select 'On'
- Bluetooth Friendly Name - Leave & Continue
- Bluetooth Security - Select '3'
- Bluetooth Authentication PIN - Leave & Continue
- Bluetooth Bonding - Select 'On' & End Wizard
Bluetooth setup is not required for wireless use but is a part of the Connection Wizard. Press continue until you finish the Wizard. See below for a full video tutorial:
Step 2: Install the Zebra Driver to your computer. The driver is located in our company Dropbox under AA ESG -> ESG Tech -> Zebra Driver or by selecting Download Zebra Driver Now.
Step 3: Register the printer's wireless connection to your desired WIFI. After installing the driver to your computer, you will be prompted to select one of 4 different methods of printer installation (Network Port, USB Port, Bluetooth Port, Other). Select Network Port.
If you successfully went through the Connection Wizard on your printer, your printer should have it's own IP address which will be detected on your network. Select your desired printer and install after clicking Add.
Step 4: After successfully adding the printer, you can select 'Open printing preferences' to manually configure your printers settings. You will not need to change any settings after the 'Operation Mode' page.
If your printer has a cutter, you would select 'Cutter' under 'Operation Mode' > 'Mode:' > 'Cutter'
Once you have completed all these steps, you are all set to use your Zebra ZD621 wirelessly